X164_AKB; 4; 51, en-US
d2ureepe,
2009-03-23T09:27:13+01:00 - Seite 334
Version: 2.11.8.1
Replacing wiper blades
334
Correct headlamp adjustment is extremely
important. High beam adjustments
simultaneously aim the low beam. To check
and readjust a headlamp, follow the steps
described:
i If it is not possible to obtain a proper
headlamp adjustment, have the system
checked at an authorized Mercedes-Benz
Center.
X Park the vehicle on a level surface 25 feet
Replacing wiper blades
Safety notes
(7.6
m) from a vertical test screen or wall.
X Make sure the vehicle has a normal tailgate
load.
X Switch on the low beam headlampsL.
G Warning!
For safety reasons, switch off the wipers and
remove the SmartKey from the starter switch
(vehicles with KEYLESS-GO: Make sure the
vehicle’s on-board electronics have status 0)
before replacing a wiper blade. Otherwise, the
wiper motor could suddenly turn on and cause
injury.
If the beam does not show a beam pattern as
indicated in the figure left, then follow the
steps below:
X Open the hood (Y page 228).
G Warning!
Wiper blades are components that are subject
to wear and tear. Replace the wiper blades
twice a year, preferably in the spring and fall.
Otherwise the windows will not be wiped
properly. As a result, you may not be able to
observe surrounding traffic conditions and
could cause an accident.
The adjustment screws are located under the
cover panel.
!
arm is folded forward.
Never open the hood when a front wiper
X Insert a suitable tool into the openings in
the panel cover. The direction of arrows
Hold on to the wiper when folding a wiper
arm back. If released, the force of the
impact from the tensioning spring could
crack the windshield or the rear window.
Do not allow a wiper arm to contact the
windshield glass or the rear window
without a wiper blade inserted.
Mercedes-Benz recommends that you have
this work carried out at an authorized
Mercedes-Benz Center.
=
and? indicate the angle in which the
tool has to be inserted in oder to access the
adjustment screws.
X Always turn the adjustment screws equally
for vertical adjustment until the headlamp
is adjusted as shown in:. Turn clockwise
for upward movement and
counterclockwise for downward
movement.
Graduations:
X Remove the SmartKey from the starter
switch.
RScrew at arrow=: 0.67° pitch
RScrew at arrow?: 0.50° pitch
Vehicles with KEYLESS-GO:
X Make sure the vehicle’s on-board
electronics have status 0 (Y page 80).
The left and right headlamps must be
adjusted individually.
| Categories | Mercedes-Benz GL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz GL350 BlueTEC, Mercedes-Benz GL450, Mercedes-Benz GL500, Mercedes-Benz GL550, Mercedes-Benz X164 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4.33 out of 5)
Automotive readers have rated 2010 Mercedes-Benz GL350 BlueTEC GL450 GL500 GL550 X164 Owners Manual 4.3 out of 5.0 based on 3 product reviews.