DO-IT-YOURSELF MAINTENANCE
6
. Loosen the oil filter upper cap with a proper
tool from the lower case until an O-ring is
seen. Then, drain the oil completely.
Pull out the oil filter upper cap with element
from the lower case.
Using a clean cloth, remove any dirt or oil
accumulated around the lower case.
Install a new copper washer of the oil filter
drain plug by the side of lower case and
retighten by turning it clockwise.
NOTE:
G050B01A-AAT
Recommended Engine Coolant
Always dispose of used engine oil in an
environmentally acceptable manner. It is sug-
gested that it be placed in a sealed container
and taken to a service station for maybe
reclaimation. Do not pour the oil on the
ground or put it into the household trash.
Gasoline engine
7.
8.
WARNING:
Used motor oil may cause irritation or cancer
of the skin if left in contact with the skin for
prolonged periods of time. Wash your hands
thoroughly with soap and warm water as
soon as possible after handling used oil.
Tightening torque : 0.8 ~ 1.0 kgf.m
9.
After mounting a new oil filter element and
new O-ring to upper cap, install the upper
cap to lower case and retighten by turning it
clockwise. Do not over-tighten.
G050B01FC
Diesel engine
G050A01A-AAT
CHECKING AND CHANGING THE
ENGINE COOLANT
WARNING:
Tightening torque : 2.3 ~ 2.5 kgf.m
10.Refill
the crankcase with the recommended
Do not remove the radiator cap when the
engine is hot. When the engine is hot, the
engine coolant is under pressure and may
erupt through the opening if the cap is
removed. You could be seriously burned if
you do not observe this precaution. Do not
remove the radiator cap until the radiator is
cool to the touch.
engine oil. Refer to the specification in chap-
ter 9 for engine oil capacity.
11.Start the engine and check to be sure no oil
is leaking from the drain plug or oil filter.
12.Shut off the engine and recheck the oil level.
NOTE:
G050B02FC
It is recommended that the engine oil and
filter should be changed by an authorized
Hyundai dealer.
Use a high quality ethylene-glycol coolant in a
mix with water. The engine coolant should
50/50
be compatible with aluminum engine parts.
Additional corrosion inhibitors or additives should
not be used. The cooling system must be main-
tained with the correct concentration and type
of engine coolant to prevent freezing and corro-
6-8
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)