OWNER MAINTENANCE
FLUID RECOMMENDATION
SG250A1-E
REPLACING LIGHT BULBS
Only automatic transmission fluid meeting the
specification of PSF-3 should be used in the
power steering system.
In the event of bulb failure being experienced,
ensure that the relative lighting circuit is turned
off prior to attempting to replace the bulb. The
illustrations on the following page will assist in
locating and removing the various bulbs. En-
sure that the replacement bulb has the same
cap configuration and wattage as the original.
SG230B1-E
POWER STEERING HOSES
Power steering hoses should be checked for
damage, deterioration and leakage at each ser-
vice.
CAUTION:
Keep the lamps out of contact with petro-
leum product, such as oil, gasoline, etc.
G300B01FC
G300A01B-GAT
REMOVALOF WATERFROMTHEFUEL
FILTER (DIESEL ENGINE)
1. Loosen the drain plug at the bottom of the
fuel filter.
2. Tighten the drain plug when water no longer
comes out.
G270A02A-GAT
HEADLIGHT BULB
3.
Check to be sure that the warning lamp
illuminates when the ignition key is turned
to "ON", and that it goes off when the
engine is started.
Replacement instructions:
If in doubt, consult your nearest authorized
HYUNDAI dealer.
WARNING:
Be sure to carefully wipe away any water
drained out in this manner, because the
fuel mixed in the water might be ignited
and result in a fire.
G300A01FC
If the fuel filter warning lamp illuminates during
driving, it indicates that water has accumu-
lated in the fuel filter. If this occurs, remove the
water as described.
G270A01FC
1.
2.
Allow the bulb to cool. Wear eye protection.
Always grasp the bulb by its plastic base,
avoid touching the glass.
3.
Disconnect the power cord from the bulb
6-19
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)