IN CASE OF EMERGENCY
SD070G1-E
SD070H1-E
WARNING:
5.
Raising the Car
6. Changing Wheels
It is important that the faces of the wheel
and hub are clean prior to installing the
wheel. The prescence of dirt or other mat-
ter in the wheel or hub faces could result in
the wheel nuts becoming loose whilst the
vehicle is being driven.
Wrench bar
SD070I1-E
7.
Re-install Wheel Nuts
Wheel nut wrench
HFC4022
D060G01FC
After inserting a wrench bar into the wheel nut
wrench, install the wrench bar into the jack as
shown in the drawing. To raise the vehicle, turn
the wheel nut wrench clockwise. As the jack
begins to raise the vehicle, double check that it
is properly positioned and will not slip. If the jack
is on soft ground or sand, it may be necessary
to place a stout piece of timber under the base
of the jack to prevent it from sinking.
Using the wheel brace, remove the nuts and
slide the wheel off the hub and wheel studs.
Lie the wheel flat to prevent it from rolling.
Ensure that the faces of the wheel and hub
are clean. Position the spare wheel over the
studs and slide it up to the hub.
D060H01FC-D
Raise the car high enough so that the fully
inflated spare wheel can be installed.
Fit the wheel nuts onto the studs and tighten
with the wheel brace.
WARNING:
Do not get under the car when it is support-
ed by the jack! The jack is solely designed
for wheel changing and is not intended to
support the vehicle for other purposes. The
use of purpose designed supports is neces-
sary whilst the vehicle is raised and the
operator is required to get underneath.
STA3071H
3-6
| Categories | Hyundai Manuals, Hyundai Matrix Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Matrix |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)