Controls in detail
Useful features
Reprogramming a single signal trans-
mitter button
Operation of integrated remote control
Erasing the integrated remote control
memory
̈
̈
Switch on the ignition (୴ page 34).
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈ Switch on the ignition (୴ page 34).
Select and press the appropriate inte-
grated signal transmitter button (2,
̈ Simultaneously press and hold down
the outer signal transmitter buttons 2
and 4, for approximately 20 seconds,
until the indicator lamp 1 flashes rap-
idly. Do not hold for longer than
3
or 4) to activate the remote con-
̈
̈
Switch on the ignition (୴ page 34).
trolled device.
Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
30
seconds.
20
seconds.
The codes of all three channels are
erased.
̈
The indicator lamp 1 will begin to
flash after 20 seconds. Without releas-
ing the signal transmitter button, pro-
ceed with programming starting with
step 3.
i
If you sell your vehicle, erase the codes
of all three channels.
254
| Categories | Mercedes-Benz CL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CL500, Mercedes-Benz CL55 AMG, Mercedes-Benz CL600, Mercedes-Benz CL65 AMG, Mercedes-Benz W215 |
| Model Year | 2006 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)