Getting started
Parking and locking
Turning off with the SmartKey
Turning off the engine with
KEYLESS-GO*
Releasing seat belts
̈
Turn the SmartKey in the starter switch
̈
Press the seat belt release button
(
୴ page 34) to position 0 and remove ̈ Place the gear selector lever in
(
୴ page 47).
it.
position P.
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
The immobilizer is activated.
̈ Press the KEYLESS-GO start/stop but-
ton (୴ page 35) to shut off the engine.
i
With the driver’s door closed, the start-
er switch is now in position 1. With the
driver’s door opened, the starter switch
is set to position 0, same as SmartKey
removed from starter switch
The SmartKey can only be removed
from the starter switch with the gear
selector lever in position P.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
i
(୴ page 34).
With the SmartKey removed and the
driver’s door open, a warning sounds if
the vehicle’s exterior lamps are not
switched off.
i
If you hear a warning signal, you have
either
ț
forgotten to turn off the lights be-
fore opening the driver’s door
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
or
ț
tried to turn off the engine while the
gear selector lever is not in P.
Turn off the lights or place the gear
selector lever in P.
59
Product Specification
Categories | Mercedes-Benz CL-Class Manuals, Mercedes-Benz Manuals |
---|---|
Tags | Mercedes-Benz CL500, Mercedes-Benz CL55 AMG, Mercedes-Benz CL600, Mercedes-Benz CL65 AMG, Mercedes-Benz W215 |
Model Year | 2006 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |