Controls in detail
Useful features
୴
୴Step 2:
Step 3:
Step 5:
̈
If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
̈ Hold end of hand-held remote
control 5 of the device you wish to
train approximately 2 to 5 in
(5 to12 cm) away from signal trans-
mitter button (2, 3 or 4) to be
programmed, while keeping indicator
lamp 1 in view.
̈ After indicator lamp 1 changes from a
slow to a rapidly flashing light, release
the hand-held remote control button
and the signal transmitter button.
If you are programming the integrated
remote control for the first time, press
and hold outer signal transmitter
buttons 2 and 4 and release them
only when indicator lamp 1 begins to
flash after approximately 20 seconds
(do not hold the button for longer than
Step 6:
̈
Press and hold the just-trained signal
transmitter button (2, 3, or 4) and
observe indicator lamp 1.
Step 4:
̈
Using both hands, simultaneously
press hand-held remote control
button 6 and the desired signal
transmitter button (2, 3, or 4). Do
not release the buttons until step 5 is
completed.
If indicator lamp 1 stays on
constantly, programming is complete
and your device should activate when
the respective signal transmitter
button (2, 3, or 4) is pressed and
released.
30
seconds). This procedure erases
any previous settings for all three
channels and initializes the memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and
begin directly with step 3.
Indicator lamp 1 will flash, first slowly
and then rapidly.
i If indicator lamp 1 flashes rapidly for about
2 seconds and then turns to a constant light,
continue with programming steps 8 through 12
as your garage door opener may be equipped
with the “rolling code” feature.
i Indicator lamp 1 flashes immediately the
first time the signal transmitter button is
programmed. If this button has already been
programmed, the indicator lamp will only start
flashing after 20 seconds.
Step 7:
̈
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
238
| Categories | Mercedes-Benz G-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes Benz W463, Mercedes-Benz G500, Mercedes-Benz G55 AMG |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)