Controls in detail
Useful features
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Operation of integrated remote control
i Upon completion of programming the
integrated remote control, make sure you retain
the hand-held remote control that came with the
garage door opener, gate operator or other
device. You may need it for use in other vehicles,
for future programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
̈
̈
Switch on the ignition (୴ page 39).
Select and press the appropriate signal
transmitter button (2, 3, or 4) to
activate the remote controlled device.
Step 4:
The integrated remote control
transmitter continues to send the
signal as long as the button is
pressed – up to 20seconds.
̈
Press and hold the signal transmitter
button (2, 3, or 4). Do not release
this button until it has been success-
fully trained.
Reprogramming a single signal
transmitter button
̈
While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this
sequence on the hand-held remote
control until the frequency signal has
been learned. Upon successful train-
ing, indicator lamp 1 will flash slowly
and then rapidly after several seconds.
Erasing the integrated remote control
memory
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈
Switch on the ignition (୴ page 39).
̈
̈
Switch on the ignition (୴ page 39).
̈ Simultaneously press and hold outer
signal transmitter buttons 2 and 4,
for approximately 20 seconds, until
indicator lamp 1 blinks rapidly. Do not
hold for longer than 30 seconds.
Press and hold the desired signal
transmitter button (2, 3, or 4).
Do not release the button.
̈
Indicator lamp 1 will begin to flash
after 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
The codes of all three channels are
erased.
i If you sell your vehicle, erase the codes of all
three channels.
̈
Proceed with programming step 5 and
step 6 to complete.
240
| Categories | Mercedes-Benz G-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes Benz W463, Mercedes-Benz G500, Mercedes-Benz G55 AMG |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)