164_AKB;
d2ureepe,
6; 2, en-US
2009-03-25T14:36:45+01:00 - Seite 206
Version: 2.11.8.1
Useful features
206
X Step 8: Locate the “training” button on the If you live in Canada or if you are having
garage door opener motor head unit.
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
i Exact location and color of the button may
vary by garage door opener brand.
Depending on manufacturer, the “training”
button may also be referred to as “learn” or
“smart” button. If there is difficulty locating
the transmitting button, refer to the garage
door opener Operator’s Manual.
X Step 4: Press and hold the signal
transmitter button (;,= or?). Do not
release this button until it has been
successfully trained.
X While still holding down the signal
transmitter button (;,= or?), “cycle”
your hand-held remote control buttonB
as follows: Press and hold buttonB for
X Step 9: Press the “training” button on the
garage door opener motor head unit.
The “training light” is activated.
You have 30 seconds to initiate the
following two steps.
X Step 10: Return to the vehicle and firmly
press, hold for 2 seconds and release the
programmed signal transmitter button (;,
2
seconds, then release it for 2 seconds,
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Upon successful training, indicator
lamp: will flash slowly and then rapidly
after several seconds.
=
or?).
X Step 11: Press, hold for 2 seconds and
release same signal transmitter button a
second time to complete the training
process.
X Proceed with programming step 5 and
step 6 to complete.
i Some garage door openers (or other
rolling code equipped devices) may require
you to press, hold for 2 seconds and
release the same signal transmitter button
a third time to complete the training
process.
i Upon completion of programming the
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
X Step 12: Confirm the garage door
operation by pressing the programmed
signal transmitter button (;,= or?).
X Step 13: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
Reprogramming a single signal
transmitter button
Gate operator/Canadian programming
To program a device using a signal
transmitter button previously trained, follow
these steps:
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission which
may not be long enough for the integrated
signal transmitter to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
“time-out” in the same manner.
| Categories | Mercedes-Benz M-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz ML350, Mercedes-Benz ML350 BlueTec, Mercedes-Benz ML550, Mercedes-Benz ML63 AMG, Mercedes-Benz W164 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)