164_AKB;
d2ureepe,
6; 2, en-US
2009-03-25T14:36:45+01:00 - Seite 326
Version: 2.11.8.1
Flat tire
326
If the tire inflation pressure is at least 20 psi
Ralignment bolt
(1.3
bar), inflate or deflate the tire to the
Relectric air pump (required for vehicles
with spare wheel with collapsible tire
only)
correct tire inflation pressure (see Tire and
Loading Information placard on the driver’s
door B-pillar):
For information on where to find the
respective items, see “Where will I find ...?”
Y page 270) and (Y page 273).
X To increase tire inflation pressure:
Switch on the electric air pump.
X To decrease tire inflation pressure:
Version 1: Open vent screwF on
pressure gaugeG (Y page 324).
Version 2: Press deflate buttonF located
(
i Vehicles without spare wheel are not
factory-equipped with the tools required for
a wheel change such as a jack or a wheel
wrench. Some tools required for a wheel
change are specific to your vehicle.
at the end of the filler hose.
G Observe Safety notes, see page 223.
X Drive to the nearest qualified workshop,
e.g. an authorized Mercedes-Benz Center,
to have the damaged tire replaced.
X Recommended duration of use: A
maximum of 300 miles (500 km) at 50 mph
Contact an authorized Mercedes-Benz
Center to obtain the tools approved for
your vehicle. This section describes the
wheel change using the tools approved and
recommended for your vehicle.
Lifting the vehicle
G Warning!
(80
km/h) or below with the recommended
tire inflation pressure.
X Contact an authorized Mercedes-Benz
Center as soon as possible to obtain a new
TIREFIT kit.
When jacking up the vehicle, only use the jack
which has been specifically approved by
Mercedes-Benz for your vehicle.
X Bring used TIREFIT materials to an
authorized Mercedes-Benz Center for
proper disposal.
The jack is designed exclusively for jacking up
the vehicle at the jack take-up brackets built
into both sides of the vehicle. Make sure the
jack arm is fully seated in the jack take-up
bracket. The jack must always be vertical
when in use, especially on inclines or
declines.
X Replace your TIREFIT container every
4
years. Replacement containers are
available at any authorized Mercedes-Benz
Center.
The jack is intended only for lifting the vehicle
briefly for wheel changes. It is not suited for
performing maintenance work under the
vehicle. To help avoid personal injury, use the
jack only to lift the vehicle during a wheel
change.
Mounting the spare wheel
Introduction
X Prepare the vehicle as described
(
Y page 322).
Never get beneath the vehicle while it is
supported by the jack. Keep hands and feet
away from the area under the lifted vehicle.
Always lower the vehicle onto sufficient
capacity jackstands before working under the
vehicle.
X Take the following out of the vehicle:
Rspare wheel
Rjack
Rwheel wrench
Always engage the parking brake firmly and
block the wheels with wheel chocks or other
Rcollapsible wheel chock
| Categories | Mercedes-Benz M-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz ML350, Mercedes-Benz ML350 BlueTec, Mercedes-Benz ML550, Mercedes-Benz ML63 AMG, Mercedes-Benz W164 |
| Model Year | 2010 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)