Air suspension
CONTROLS
Ride height selector (1)
Press and release the upper or lower arrow on
the rocker switch to raise or lower the vehicle
to the next ride height setting (the relevant
indicator light will illuminate).
’Inhibit’ switch (2)
The indicator light in the switch illuminates as
a bulb checkwhen the starter is initiallyturned
to position ’II’.
Your vehicle is fitted with an electronically
controlled air suspension system (EAS) which
provides five different ride height settings
including an ’Access’mode. These settings
increase or decrease the height and ground
clearance of your vehicle to cope with
different driving conditions.
•
Press the switch to select ’Inhibit’mode
(indicator light illuminates). This will
prevent automatic changes between
Standard and Low ride height.
•
Press again to switch off.
In addition, the EAS also provides automatic
suspension levelling.
NOTE: Even in ’Inhibit’mode, the ride height
can automaticallychange from
’Access’/’Crawl’to the ’Low’ride height and
from Extended or High profile to High or
Standard.
Before operating EAS
Remember, even if a change of ride height is
selected, it will NOTtake place:
•
•
If the tailgate or any door is open.
Whilst the footbrake is continouslyapplied
for less than 3 minutes.
Ride height indicator panel (3)
All indicator lights illuminate as a bulb check
when the starter switch is initiallyturned to
position ’II’and remain illuminated until the
engine is started.
•
If the engine is not running (except for
selection of ’Access’within 40 seconds of
switching off).
Each specific indicator light illuminates when
a height setting is in operation. When a
change in height is activated, the indicator
lights illuminate in the following sequence:
If the ’Access’mode is required, ensure the
handbrake is applied (select ’P’for automatic
transmission).
NOTE: Frequent changes between ride
heights could cause the compressor to
overheat. If this occurs, EAS will be fully
operationalagain after a few minutes when
the compressor has cooled.
•
•
The new height indicator light flashes.
When the new height is reached, its
indicator light stops flashing and
illuminates continuously(the previous
indicator light extinguishes).
110
Categories | Range Rover |
---|---|
Tags | Land Rover |
Model Year | 1998 |
Download File |
|
Language | English |
Product Brand | Land Rover |
Applicable to Country | Australia |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)