Controls in detail
Useful features
Programming the integrated remote
control
X Step 4: Using both hands, simultaneously
press hand-held remote control button 6
and the desired signal transmitter button
programming steps 8 through 12 as your
garage door opener may be equipped with
the “rolling code” feature.
X Step 1: Switch on the ignition.
(
2, 3 or 4). Do not release the buttons
X Step 7: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
X Step 2: If you have previously programmed
a signal transmitter button and wish to
retain its programming, proceed to step 3.
until step 5 is completed.
Indicator lamp 1 will flash, first slowly and
then rapidly.
or
Rolling code programming
i Indicator lamp 1 flashes immediately
the first time the signal transmitter button
is programmed. If this button has already
been programmed, the indicator lamp will
start flashing after 20 seconds.
X If you are programming the integrated
remote control for the first time, press and
hold the two outer signal transmitter
buttons 2 and 4 and release them when
indicator lamp 1 begins to flash after
approximately 20 seconds.
To train a garage door opener (or other rolling
code devices) with the rolling code feature,
follow these instructions after completing the
“Programming” portion (steps 1 through 6) of
this text. A second person may make the
following training procedures quicker and
easier.
X Step 5: After indicator lamp 1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter button.
X Step 6: Press and hold the just-trained
signal transmitter button (2, 3 or 4) and i Exact location and color of the button may
vary by garage door opener brand.
observe indicator lamp 1.
If indicator lamp 1 stays on constantly,
programming is complete and your device
should activate when the respective signal
transmitter button (2, 3 or 4) is pressed
and released.
Do not hold the button for longer than
30
seconds.
X Step 8: Locate the “training” button on the
garage door opener motor head unit.
This procedure erases any previous
settings for all three channels and
initializes the memory. If you later wish to
program a second and/or third hand-held
transmitter to the remaining two signal
transmitter buttons, do not repeat this step
and begin directly with step 3.
X Step 3: Hold the end of hand-held remote
control 5 of the device you wish to train
approximately 2 to 12 in (5 to 30 cm) away
from the signal transmitter button (2, 3
or 4) to be programmed, while keeping
indicator lamp 1 in view.
Depending on manufacturer, the “training”
button may also be referred to as “learn”or
“smart” button. If there is difficulty locating
the transmitting button, refer to the garage
door opener Operator’s Manual.
X Step 9: Press the “training” button on the
garage door opener motor head unit.
The “training light” is activated.
i If indicator lamp 1 flashes rapidly for
approximately 2 seconds and then turns to
a constant light, continue with
232
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E300, Mercedes-Benz E320 BlueTec, Mercedes-Benz E350, Mercedes-Benz E63 AMG, Mercedes-Benz W211 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)