Controls in detail
Useful features
You have 30 seconds to initiate the
following two steps.
X Step 10: Return to the vehicle and firmly
press, hold for 2 seconds and release the
programmed signal transmitter button
signal transmitter to pick up the signal during i Upon completion of programming the
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
“time-out” in the same manner.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4 with
the following:
integrated remote control, make sure you
retain the hand-held remote control that
came with the garage door opener, gate
operator or other device. You may need it
for use in other vehicles, for future
programming of an integrated remote
control, or simply for continued use as a
hand-held remote control to operate the
respective device in other situations.
(
2, 3 or 4).
X Step 11: Press, hold for 2 seconds and
release same signal transmitter button a
second time to complete the training
process.
X Step 4: Press and hold the signal
transmitter button (2, 3 or 4). Do not
release this button until it has been
successfully trained.
i Some garage door openers (or other
rolling code equipped devices) may require
you to press, hold for 2 seconds and
release the same signal transmitter button
a third time to complete the training
process.
Reprogramming a single signal
transmitter button
X While still holding down the signal
transmitter button (2, 3 or 4), “cycle”
your hand-held remote control button 6
as follows: Press and hold button 6 for
To program a device using a signal
transmitter button previously trained, follow
these steps:
X Switch on the ignition.
X Step 12: Confirm the garage door
operation by pressing the programmed
signal transmitter button (2, 3 or 4).
X Step 13: To program the remaining two
signal transmitter buttons, repeat the steps
above starting with step 3.
2
seconds, then release it for 2 seconds,
X Press and hold the desired signal
transmitter button (2, 3 or 4). Do not
release the button.
and again press and hold it for 2 seconds.
Repeat this sequence on the hand-held
remote control until the frequency signal
has been learned.
Indicator lamp 1 will begin to flash after
20
seconds.
Upon successful training, indicator lamp
X Without releasing the signal transmitter
button, proceed with programming starting
with step 3.
1
will flash slowly and then rapidly after
Gate operator/Canadian programming
several seconds.
X Proceed with programming step 5 and
step 6 to complete.
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission which
may not be long enough for the integrated
Z
233
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E300, Mercedes-Benz E320 BlueTec, Mercedes-Benz E350, Mercedes-Benz E63 AMG, Mercedes-Benz W211 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)