Controls in detail
Useful features
Operation of integrated remote control Programming tips
batteries are in the hand-held remote
control before beginning the procedure.
X Switch on the ignition.
If you are having difficulty programming the
RStraighten the antenna wire from the
garage door opener assembly. This may
help improve transmitting and/or receiving
signals.
X Select and press the appropriate
integrated signal transmitter button (2,
3
integrated remote control, here are some
helpful tips:
or 4) to activate the remote controlled RCheck the frequency of hand-held remote
device.
control 5 (typically located on the reverse
side of the remote). The integrated remote
control is compatible with radio-frequency
devices operating between 280-390 MHz.
The integrated remote control transmitter
continues to send the signal as long as the
button is pressed – up to 20 seconds.
i Certain types of garage door openers are
incompatible with the integrated remote
control. If you should experience further
difficulties with programming the
integrated remote control, contact an
authorized Mercedes-Benz Center, or call
the Mercedes-Benz Customer Assistance
Center (in the USA) at
RPut a new battery in hand-held remote
control 5. This will increase the likelihood
of the hand-held remote control sending a
faster and more accurate signal to the
integrated remote control.
Erasing the integrated remote control
memory
i If you sell your vehicle, erase the codes of
all three channels.
1-800-FOR-MERCedes,
or Customer
RWhile performing step 3, hold hand-held
remote control 5 at different lengths and
angles from the signal transmitter button
Service (in Canada) at 1-800-387-0100.
X Switch on the ignition.
X Simultaneously press and hold outer signal
transmitter buttons 2 and 4, for
approximately 20 seconds, until indicator
lamp 1 flashes rapidly. Do not hold for
longer than 30 seconds.
i USA only:
(
2, 3 or 4) you are programming.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
Attempt varying angles at the distance of 2
to 12 inches (5 to 30 cm) away or the same
angle at varying distances.
1.
This device may not cause harmful
interference, and
The codes of all three channels are erased.
RIf another hand-held remote control is
available for the same device, try the
programming steps again using that other
hand-held remote control. Make sure new
2.
this device must accept any
interference received, including
interference that may cause undesired
operation.
234
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E300, Mercedes-Benz E320 BlueTec, Mercedes-Benz E350, Mercedes-Benz E63 AMG, Mercedes-Benz W211 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)