Technical data
Fuels, coolants, lubricants etc.
not meeting Mercedes-Benz approved fuel
standards.
Contact an authorized Mercedes-Benz Center ! Add premixed coolant solution only.
or visit www.mbusa.com (USA only) for a
listing of approved product(s). Follow
directions on product label.
Do not blend other fuel additives with fuel.
This only results in unnecessary cost and may
Adding water and MB 325.0 Anticorrosion/
Antifreeze separately from each other,
could cause engine damage not covered by
the Mercedes-Benz Limited Warranty.
Gasoline additives (gasoline engine)
A major concern among engine
If the antifreeze mixture is effective to -35‡
manufacturers is carbon build-up caused by be harmful to the engine operation.
(-37†),
the boiling point of the coolant in the
gasoline. Mercedes-Benz recommends only
pressurized cooling system is reached at
approximately 266‡ (130†).
!
poor fuel quality or from blending additional
Damage or malfunction resulting from
the use of quality gasoline containing
additives that prevent the build-up of carbon
deposits.
After an extended period of using fuels
without such additives carbon deposits can
build up, especially on the intake valves and
in the combustion area, leading to engine
performance problems such as:
fuel additives other than those tested and The coolant solution must be used year round
approved by us for use on Mercedes-Benz to provide the necessary corrosion protection
vehicles are not covered by the Mercedes- and increase boil-over protection. Refer to
Benz Limited Warranty or by any pre-owned the Maintenance Booklet for replacement
or Extended Limited warranties.
interval.
Coolant system design and coolant used
determine the replacement interval. The
replacement interval published in the
Coolants
RWarm-up hesitation
RUnstable idle
RKnocking/pinging
RMisfire
The engine coolant is a mixture of water and Maintenance Booklet is only applicable if
anticorrosion/antifreeze, which provides:
MB 325.0 Anticorrosion/Antifreeze solution
or other Mercedes-Benz approved products
of equal specification are used to renew the
coolant concentration or bring it back up to
RCorrosion protection
RFreeze protection
RPower loss
RBoiling protection (by increasing the boiling the proper level.
In areas where carbon deposits may be
encountered due to lack of availability of
gasoline which contains these additives,
Mercedes-Benz recommends the use of
additives approved by us for use on
Mercedes-Benz vehicles.
point)
For information on other Mercedes-Benz
approved products of equal specification,
contact an authorized Mercedes-Benz Center
or visit www.mbusa.com (USA only).
To provide important corrosion protection,
the solution must be at least 50%
The cooling system was filled at the factory
with a coolant providing freeze protection to
approximately -35‡ (-37†) and corrosion
protection.
400
| Categories | Mercedes-Benz E-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz E300, Mercedes-Benz E320 BlueTec, Mercedes-Benz E350, Mercedes-Benz E63 AMG, Mercedes-Benz W211 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)