Controls in detail
Useful features
Step 12:
Step 4:
i Upon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
rage door opener, gate operator or other device.
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
̈
Confirm the garage door operation by
̈ Press and hold the signal transmitter
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
pressing the programmed signal trans-
mitter button (2, 3 or 4).
Step 13:
̈
While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training,
indicator lamp 1 will flash slowly and
then rapidly after several seconds.
̈
To program the remaining two signal
transmitter buttons, repeat the steps
above starting with step 3.
Reprogramming a single signal trans-
mitter button
Gate operator/Canadian programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission
which may not be long enough for the
integrated signal transmitter to pick up the
signal during programming. Similar to this
Canadian law, some U.S. gate operators
are designed to “time-out” in the same
manner.
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈
̈
Switch on the ignition (୴ page 40).
Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
̈
Proceed with programming step 5 and
step 6 to complete.
̈
Indicator lamp 1 will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
319
| Categories | Mercedes-Benz M-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz ML320 CDI, Mercedes-Benz ML350, Mercedes-Benz ML500, Mercedes-Benz ML63 AMG, Mercedes-Benz W164 |
| Model Year | 2007 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(2 votes, average: 4 out of 4)
Automotive readers have rated 2007 Mercedes-Benz ML320 CDI ML350 ML500 ML63 AMG Owners Manual 4.0 out of 4.0 based on 2 product reviews.