UNDERSTANDINGTHEFEATURESOFYOURVEHICLE
63
NOTE: If the driver’s door is left open, and the head -
lights or parking lights are left on, the “High Beam
Ind icator Light” will flash and a chim e will sou nd .
FrontFogLights—IfEquipped
The front fog light switch is in the multi-function
control lever. To activate the front fog lights, turn
on the parking or low beam head lights and pull
Lights-OnReminder
out the end of the lever.
If the head lights or parking lights are on after the ignition
is turned off, a chim e will sou nd when the driver’s door
is opened .
3
NOTE: The fog lights will only operate with the parking
lights or the head lights on low beam . Selecting high
beam head lights will turn off the fog lights.
HeadlightDimmerSwitch
Pull the multi-function control lever tow ard s you to
switch the head lights to HIGH beam . Pull the muti-
function control lever a second time to switch the head -
lights to LOW beam .
TurnSignals
Move the multi-function control lever up or down and
the arrow s on each side of the instru ment cluster flash to
show prop er operation of the front and rear turn signal
lights. You can signal a lane change by moving the lever
partially up or down withou t moving beyond the detent.
PassingLight
You can signal another vehicle with you r head lights by
lightly pulling the multi-function control lever tow ard
the steering wheel. This will cause the head lights to turn
on at high beam and rem ain on until the lever is released .
If either light rem ains on and does not flash, or there is a
very fast flash rate, check for a defective outsid e light
| Categories | Jeep Manuals, Jeep Wrangler Manuals |
|---|---|
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)