Land Rover HomeLink®
4.
5.
Using both hands, push the hand-held
Training a garage door opener equipped
with ’rolling codes’
To train your ’rolling code’garage door
opener to operate from your HomeLink
Transmitter, follow these steps:
transmitter button and the desired button
on the HomeLinkTransmitter. Continue to
press both buttons through step 5.
Hold down both buttons until you see the
red light on the Land Rover HomeLink
Transmitter flash, first slowlyand then
rapidly. It indicates that you have
successfullyprogrammed the HomeLink
Transmitter to learn the new frequency
signal. Release both buttons once the
rapid flashing begins.
1. Program your hand-held transmitter to the
HomeLinkTransmitter by following the
procedures outlined in ’Programming’ , (if
you alreadycompleted this programming,
proceed to the next instruction).
2.
Train your garage door opener receiver to
recognize your HomeLinkTransmitter:
(your garage door opener receiver will
learn to recognize the HomeLink
Operating the Land Rover HomeLink
Transmitter
Once it is programmed, the HomeLink
Transmitter can be used in place of your
hand-held transmitter(s). To operate, simply
press the appropriate button on the HomeLink
Transmitter. The red light comes on while the
signalis being transmitted.
Transmitter by following the same process
used to train the hand-held transmitter)
a) Remove the cover panel from your
garage door opener receiver (the receiver
should be located by the garage door
motor).
b) Locate the training button on the
garage door opener receiver. The exact
location and colour of the button may vary
by garage door opener brand. If you have
difficultylocating the training button,
reference your garage door opener
manual, or call1-800-355-3515.
NOTE: If your hand-held transmitter appears
to program the HomeLink Transmitter, but
does not open your garage door and, if your
garage door was manufactured after 1995,
your garage door opener may have a ’code
protected’or ’rolling code’feature.
A’rolling code’type of system will change the
c) Press the training button on the garage
door opener receiver for 1-2 seconds.
d) Return to the HomeLinkTransmitter in
the vehicle and depress the programmed
HomeLinkTransmitter button for the
duration of the rapid flash of the
HomeLink’s red light, (1-2 seconds).
Release the button and depress the button
to confirm that the HomeLinkTransmitter
has been trained to the receiver.
’code’of your garage door opener everytime
you open or close your garage door.
To determine if you have one of these
systems, depress the button on your
HomeLinkTransmitter that you programmed.
If the red light on the HomeLinkTransmitter
flashes rapidlyfor 1-2 seconds, then turns
solid, your garage door opener has a rolling
code system.
98
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 2002 |
| Download File |
|
| Language | English |
| Product Name | Range Rover |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)