CHECKING POWER STEERING
OIL LEVEL
Check that the oil in the reservoir is at
the maximum level.
TOPPING UP THE POWER
STEERING OIL
Fig. 15: 2.0 T.SPARK - JTD - 3.2 V6
This operation must be carried out with
the car on level ground and when the en-
gine is stationary and cold.
If the level of the oil in the power steer-
ing reservoir falls below the specified lev-
el, top up only with one of the products
listed in he table of “Specifications of flu-
ids and lubricants” in the “Technical speci-
fications” chapter as follows.
24V
versions
Fig. 16: 2.0 T.SPARK - JTD - JTD 20V
Multijet versions
On 2.0 T.SPARK, JTD and JTD 20V Multi-
jet versions access to the reservoir is gained
by removing the cover (A-fig. 15) after
turning the fastening pins withdraw the
tube (B-fig. 16).
Fig. 17: 2.5 V6 24V - 3.0 V6 24V
versions
– Start the engine and allow the oil in
the reservoir to settle.
Slacken the cap (C-fig. 16-17 ) and
check that the level corresponds to the
reference notch of the maximum level on
the dipstick which is an integral part of
the cap.
– When the engine is running turn the
steering wheel lock to lock a few times.
–
Top up the MAX level notch and then
replace the cover.
fig. 15 - 2.0 T.SPARK - JTD
JTD 20V Multijet versions
fig. 16 - 2.0 T.SPARK - JTD
JTD 20V Multijet versions
fig. 17 - 2.5 V6 24V – 3.0 V6 24V
3.2 V6 24V versions
218
| Categories | Alfa Romeo 166 Manuals, Alfa Romeo Manuals |
|---|---|
| Tags | Alfa Romeo 166 2.0 T.SPARK, Alfa Romeo 166 2.5 V6 24V, Alfa Romeo 166 3.0 V6 24V, Alfa Romeo 166 3.2 V6 24V, Alfa Romeo 166 JTD |
| Model Year | 2003, 2004, 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.