ACTIVATING THE ALARM
Surveillance
DEACTIVATING THE ALARM
When the doors and boot/bonnet lids
are closed and the ignition key is in the
STOP position (key removed), point the
remote control towards the car and press
the button on the ignition key.
When the system has been turned on,
the led (A-fig. 12 ) on the dashboard
will flash to indicate that the system is in
the surveillance mode.
To deactivate the alarm press the button
on the remote control. The system per-
forms the following (with the exception
of some markets):
–
the direction indicators turn on twice
The led (A ) inside the car flashes
throughout the whole time the vehicle is
under surveillance.
briefly
With the exception of some markets the
system sounds a “BEEP”, the hazard
warning lights turn on for appr. three sec-
onds and the door lock is engaged.
– two beeps are sounded briefly by the
siren
IMPORTANT Operation of the elec-
tronic alarm is adapted at the origin to
the regulations of the different countries.
–
the doors are released.
Engagement of the alarm is preceded
by a self-diagnosis characterised by a
change in the frequency at which the led
IMPORTANT If the led in the car s-
tays on when the system has been deac-
tivated, (maximum of 2 minutes or until
the ignition key is moved to MAR ) the
following should be borne in mind:
Self-diagnosis and monitoring of
doors and bonnet/boot
(
detected the system gives off a further
“BEEP”.
A-fig. 12 ) flashes. If an anomaly is
If, after the alarm has been activated, a
second acoustic signal is heard, check
that all the doors and bonnet/boot are
closed properly and engage the system
once again.
–
if the led stays on permanently, it
means that the remote control batteries
are flat and need replacing;
if the led continues to flash, but at
–
On the other hand, if a door or bon-
net/boot lid is not correctly closed it will
not be controlled by the system.
different intervals than normal, it means
that attempts to steal the car have been
made, counting the number of flashes it
is also possible to identify the type of at-
tempt:
If the control signal is repeated when
the doors and bonnet/boot are closed
properly this means that the self-diagno-
sis function has detected a system operat-
ing fault, in which case it is necessary
contact Alfa Romeo Authorized Services.
1 flash: right front door
2
flashes: left front door
fig. 12
23
| Categories | Alfa Romeo 166 Manuals, Alfa Romeo Manuals |
|---|---|
| Tags | Alfa Romeo 166 2.0 T.SPARK, Alfa Romeo 166 2.5 V6 24V, Alfa Romeo 166 3.0 V6 24V, Alfa Romeo 166 3.2 V6 24V, Alfa Romeo 166 JTD |
| Model Year | 2003, 2004, 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.