Each time the knurled ring (B) is oper-
ated the speed increases or lowers by ap-
prox. 1 km/h. Keeping the ring turned
the speed changes continuously. The new
speed reached will be maintained auto-
matically.
gearshift lever to position N.
or
IMPORTANT In the case of need (for
example overtaking) it is possible to ac-
celerate simply pressing the accelerator
pedal; afterwards, releasing the accelera-
tor pedal, the car will resume the speed
memorised previously.
– turning the knurled ring (B) momen-
taneously to the (+) position: each pulse
of the knurled ring will correspond to a
small increase of the speed (approx. 1
km/h) while pressing continuously will
correspond to a continuous increase of
the speed. Releasing the knurled ring (B)
the new speed will remain automatically
memorised.
With button (C) it is possible to reset
the speed memorised.
IMPORTANT Turning the ignition key
to the STOP position or switch (A) to
OFF , the memorised speed is cleared
and the system is disengaged.
To restore the speed memorised
If the device has been disengaged, for
example by pressing the brake or clutch
pedal, the speed memorised can be re-
stored as follows:
To reduce the memorised speed
The memorised speed can be reduced in
two ways:
To memorise the speed
–
gradually accelerate until reaching a
Turn switch (A) to ON , wait for 2 sec-
onds at least, then bring the car to the re-
quired speed as usual by pressing the ac-
celerator pedal or by turning the ring nut
speed approaching the one memorised;
– disengaging the device (for example
pressing the brake pedal) and then mem-
orising the new speed (tur ning the
knurled ring (B) to the (+) position for
at least three seconds);
– engage the gear selected when the
speed was memorised (4th, 5th or 6th
gear);
(
B) to (+) or to (–) and then releasing
it.The car speed is memorised and it is
therefore possible to release the accelera-
tor pedal.
–
press button (C).
or
To increase the speed memorised
– keeping the knurled ring (B) pressed
on the (–) position until reaching the
new speed which will be automatically
memorised.
The car will continue to travel at the re-
quired speed until one of the following
conditions takes place:
The speed memorised can be increased
in two ways:
–
pressing the accelerator and then
–
–
–
pressing the brake pedal;
memorising the new speed reached (turn-
ing the knurled ring (B) for more than
three seconds;
pressing the clutch pedal;
inadvertently moving the automatic
65
| Categories | Alfa Romeo 166 Manuals, Alfa Romeo Manuals |
|---|---|
| Tags | Alfa Romeo 166 2.0 T.SPARK, Alfa Romeo 166 2.5 V6 24V, Alfa Romeo 166 3.0 V6 24V, Alfa Romeo 166 3.2 V6 24V, Alfa Romeo 166 JTD |
| Model Year | 2003, 2004, 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.