Control systems
COMAND navigation (introduction)
General notes
Route guidance after vehicle transpor-
tation
i Please note that the update must be allowed
to run to the end in this case. If you interrupt it,
the navigation system will continue to be non-op-
erational.
Operational readiness of the navigation
system following a system software
update by an authorized
COMAND has to redetermine the position
of the vehicle if the vehicle has been trans-
ported (e.g. by ferry, by train or after tow-
ing).
Initial use or use following a system
software update
Mercedes-Benz Center
After a system software update by an au-
thorized Mercedes-Benz Center, the in-
stalled map software may no longer be
compatible. If this is the case, the naviga-
tion system will not be operational.
Positioning takes place automatically even
when COMAND is switched off. The dura-
tion varies from one case to another.
In both these cases, the navigation system
must determine the position of the vehicle.
You may have to drive for a while before
precise route guidance is possible.
Route guidance may be restricted as fol-
lows during vehicle positioning:
You will know if this is the case, when the
following message will appear when you
switch to navigation mode: “The system
software has been updated. The map soft-
ware must be updated now. Please insert
the DVD with the map software.”
GPS reception
ț
Navigation announcements, route
guidance displays and displayed street
names are not consistent with the ac-
tual location of the vehicle.
Correct functioning of the navigation sys-
tem depends on GPS reception, among
other things. In certain situations, GPS re-
ception may be impaired, there may be in-
terference or no reception at all, e.g. in
tunnels, in multistory parking garages or
there is snow covering the trunk lid where
the GPS antenna is located. If there is
snow on the trunk lid it should be removed.
ț
ț
COMAND does not generate navigation
announcements.
̈
Updating map software: Proceed as
described in the “Updating the map
software” section (୴ page 183). Use
map software which is compatible with
the system software.
Instead of the route guidance displays,
you see the “Off Road” display and a di-
rection arrow. The direction arrow
shows the compass heading to the des-
tination.
187
Product Specification
Categories | Mercedes-Benz CL-Class Manuals, Mercedes-Benz Manuals |
---|---|
Tags | Mercedes-Benz CL550, Mercedes-Benz CL600, Mercedes-Benz CL63 AMG, Mercedes-Benz W216 |
Model Year | 2008 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
I guess it good but I have not seen it yet