Controls in detail
Useful features
If you live in Canada or if you are having
difficulties programming a gate operator
(regardless of where you live) by using the
programming procedures, replace step 4
with the following:
Operation of integrated remote control
i Upon completion of programming the inte-
grated remote control, make sure you retain the
hand-held remote control that came with the ga-
rage door opener, gate operator or other device.
You may need it for use in other vehicles, for fu-
ture programming of an integrated remote con-
trol, or simply for continued use as a hand-held
remote control to operate the respective device
in other situations.
̈
̈
Switch on the ignition (୴ page 365).
Select and press the appropriate inte-
grated signal transmitter button (2,
3
or 4) to activate the remote con-
Step 4:
trolled device.
̈
Press and hold the signal transmitter
button (2, 3 or 4). Do not release
this button until it has been successful-
ly trained.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Reprogramming a single signal trans-
mitter button
̈
While still holding down the signal
transmitter button (2, 3 or 4),
“cycle” your hand-held remote control
button 6 as follows: Press and hold
button 6 for 2 seconds, then release
it for 2 seconds, and again press and
hold it for 2 seconds. Repeat this se-
quence on the hand-held remote con-
trol until the frequency signal has been
learned. Upon successful training, indi-
cator lamp 1 will flash slowly and then
rapidly after several seconds.
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
Erasing integrated remote control
memory
̈
̈
Switch on the ignition (୴ page 365).
̈
̈
Switch on the ignition (୴ page 365).
Simultaneously press and hold outer
signal transmitter buttons 2 and 4,
for approximately 20 seconds, until
indicator lamp 1 flashes rapidly. Do
not hold for longer than 30 seconds.
Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
̈
Indicator lamp 1 will begin to flash af-
ter 20 seconds. Without releasing the
signal transmitter button, proceed with
programming starting with step 3.
The codes of all three channels are
erased.
̈
Proceed with programming step 5 and
step 6 to complete.
i If you sell your vehicle, erase the codes of all
three channels.
534
| Categories | Mercedes-Benz CL-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz CL550, Mercedes-Benz CL600, Mercedes-Benz CL63 AMG, Mercedes-Benz W216 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(3 votes, average: 5 out of 5)
Automotive readers have rated 2008 Mercedes-Benz CL550 CL600 CL63 AMG CL65 AMG Owners Manual 5.0 out of 5.0 based on 3 product reviews. I guess it good but I have not seen it yet