Operation
Driving instructions
Brakes
!
Because the ESP® operates automatically,
G
Warning!
the engine and ignition must be shut off
(SmartKey in starter switch position 0 or 1 or
KEYLESS-GO start/stop button* in position 0
or 1) when
Warning!
G
Make sure not to endanger any other road
users when carrying out these braking ma-
neuvers.
After driving in heavy rain for some time
without applying the brakes or through wa-
ter deep enough to wet brake components,
the first braking action may be somewhat
reduced and increased pedal pressure may
be necessary to obtain expected braking
effect. Maintain a safe distance from
vehicles in front.
ț
the electronic parking brake is being tested
on a brake test dynamometer
ț
the vehicle is being towed with the
front/rear axle raised
Refer to the description of the Brake Assist
System (BAS or BAS Plus*) (୴ page 67).
Active braking action through the ESP® may oth-
erwise seriously damage the brake system.
Brake pad wear or a leak in the system may
be the reason for low brake fluid level in
the reservoir.
To help prevent brake disk corrosion after
driving on wet road surfaces (particularly
salted roads), it is advisable to brake the
vehicle with considerable force prior to
parking. The heat generated serves to dry
the brakes.
The brake fluid level in the reservoir may
be too low if the red brake warning lamp in
the instrument cluster comes on while the
engine is running and an acoustic warning
sounds (୴ page 611). Observe additional
messages in the multifunction display that
may appear (୴ page 622).
Resting your foot on the brake pedal will
cause excessive and premature wear of the
brake pads.
It can also result in the brakes overheating,
thereby significantly reducing their effec-
tiveness. It may not be possible to stop the
vehicle in sufficient time to avoid an
accident.
If your brake system is normally only sub-
jected to moderate loads, you should occa-
sionally test the effectiveness of the
brakes by applying above-normal braking
pressure at higher speeds. This will also
enhance the grip of the brake pads.
Have the brake system inspected
immediately. Contact an authorized
Mercedes-Benz Center.
540
Product Specification
Categories | Mercedes-Benz CL-Class Manuals, Mercedes-Benz Manuals |
---|---|
Tags | Mercedes-Benz CL550, Mercedes-Benz CL600, Mercedes-Benz CL63 AMG, Mercedes-Benz W216 |
Model Year | 2008 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
I guess it good but I have not seen it yet