Practical interior accessories
Integrated universal remote
control*
Programming
The concept
The integrated universal remote control can
replace as many as three hand-held transmit-
ters for various remote-controlled accessories,
such as garage and gate or lighting systems.
The integrated universal remote control regis-
ters and stores signals from the original hand-
held transmitters.
1
2
Memory buttons
LED
The signal of an original hand-held transmitter
can be programmed on one of the three mem-
ory buttons 1. After this, the programmed
memory button 1 will operate the system in
question. The LED 2 flashes to confirm trans-
mission of the signal.
Fixed-code hand-held transmitters
1.
2.
Switch on ignition, refer to page 57.
When starting operation for the first time:
Press the left and right-hand memory
button 1 for approx. 20 seconds until the
LED 2 flashes quickly. All stored programs
are deleted.
Should you sell your vehicle one day, be sure to
delete the stored programs beforehand for your
safety, refer to page 106.
To prevent possible damage or injury,
before programming or using the inte-
grated universal remote control, always inspect
the immediate area to make certain that no peo-
ple, animals or objects are within the travel
range of the device. Also, comply with the
safety precautions of the original hand-held
transmitter.<
3.
Hold the original hand-held transmitter at a
distance of approx. 4 in/10 cm to 12 in/
30
cm from the memory buttons 1.
The required distance between the
hand-held transmitter and the mem-
ory buttons 1 depends on the relevant sys-
tem of the original hand-held transmitter
used.<
Checking compatibility
4.
Simultaneously press the transmit button
on the original hand-held transmitter and
the desired memory button 1 on the inte-
grated universal remote control. The LED 2
flashes slowly at first. As soon as the LED 2
flashes rapidly, release both buttons. If the
LED 2 does not flash rapidly after approx.
15 seconds, alter the distance and repeat
the step.
If you see this symbol on the packaging
or in the manual supplied with the orig-
inal hand-held transmitter, it is safe to
assume that it is compatible with the integrated
universal remote control.
If you have additional questions, please
contact your BMW center or call:
1-800-355-3515.
Information is also provided on the Internet at:
www.bmwusa.com or
5.
To program other original hand-held trans-
mitters, repeat steps 3 and 4.
www.homelink.com.
HomeLink is a registered trademark of Johnson
Controls, Inc.<
The corresponding memory button 1 is now
programmed with the signal of the original
hand-held transmitter.
105
Online Edition for Part no. 01 41 2 600 738 - © 08/08 BMW AG
| Categories | BMW 5-Series Manuals, BMW Manuals |
|---|---|
| Tags | BMW E60, BMW M5 |
| Model Year | 2009 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)