Controls in detail
Useful features
Operation of integrated remote control
Programming tips
ț
ț
If another hand-held remote control is
available for the same device, try the
programming steps again using that
other hand-held remote control. Make
sure new batteries are in the hand-held
remote control before beginning the
procedure.
̈
̈
Switch on the ignition (୴ page 40).
If you are having difficulty programming
the integrated remote control, here are
some helpful tips:
Select and press the appropriate inte-
grated signal transmitter button (2,
3
or 4) to activate the remote con-
ț
Check the frequency of hand-held
remote control 5 (typically located on
the reverse side of the remote). The in-
tegrated remote control is compatible
with radio-frequency devices operating
between 280-390 MHz.
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
Straighten the antenna wire from the
garage door opener assembly. This
may help improve transmitting and/or
receiving signals.
20
seconds.
ț
ț
Put a new battery in hand-held remote
control 5. This will increase the likeli-
hood of the hand-held remote control
sending a faster and more accurate sig-
nal to the integrated remote control.
i Certain types of garage door openers are in-
compatible with the integrated remote control. If
you should experience further difficulties with
programming the integrated remote control,
contact an authorized Mercedes-Benz Light
Truck Center, or call Mercedes-Benz Customer
Assistance Center (in the USA only) at
Erasing the integrated remote control
memory
̈
̈
Switch on the ignition (୴ page 40).
Simultaneously press and hold outer
signal transmitter buttons 2 and 4,
for approximately 20 seconds, until
indicator lamp 1 flashes rapidly. Do
not hold for longer than 30 seconds.
While performing step 3, hold
hand-held remote control 5 at differ-
ent lengths and angles from the signal
transmitter button (2, 3 or 4) you
are programming. Attempt varying
angles at the distance of 2 to 5 in
1-800-FOR-MERCedes, or Customer Service (in
Canada) at 1-800-387-0100.
The codes of all three channels are
erased.
(5
to 12 cm) away or the same angle at
varying distances.
i If you sell your vehicle, erase the codes of all
three channels.
306
| Categories | Mercedes-Benz M-Class Manuals, Mercedes-Benz Manuals |
|---|---|
| Tags | Mercedes-Benz ML320 CDI, Mercedes-Benz ML350, Mercedes-Benz ML550, Mercedes-Benz ML63 AMG, Mercedes-Benz W164 |
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)
Comments are closed.