light flashes rapidly (indicating successful pro-
gramming).
¼ press and hold both the HomeLink
and
hand-heldruption. transmitter buttons without inter- HomeLink BUTTON
REPROGRAMMINGASINGLE
NOTE:
To reprogram a HomeLink Universal Trans-
ceiverbutton,completethefollowing.
¼
position the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
Ifprogrammingagaragedooropener,etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damagetothegaragedooropenercompo-
nents.
HomeLink
surface. Hold the transmitter in
that position for up to 15 seconds. If
is not programmed within that
1. PressandholdthedesiredHomeLink but-
ton. Do not release the button until step 4
hasbeencompleted.
HomeLink
time, try holding the transmitter in another
position-keepingtheindicatorlightinviewat
alltimes.
2. When the indicator light begins to flash
slowly(after20seconds),positionthehand-
heldtransmitter2to5inches(50to127mm)
OPERATINGTHEHomeLink
UNIVERSALTRANSCEIVER
Ifyoucontinuetohaveprogrammingdifficulties,
please contact the NISSAN Consumer Affairs
Department.Thephonenumbersarelocatedin
theForewordofthisOwner’sManual.
awayfromtheHomeLink
surface.
The HomeLink Universal Transceiver (once
programmed) may now be used to activate the
garage door, etc. To operate, simply press the
3. Press and hold the hand-held transmitter
button.
appropriate programmed HomeLink
Transceiver button. The red indicator light will
illuminatewhilethesignalisbeingtransmitted.
Universal
CLEARINGTHEPROGRAMMED
INFORMATION
4.
TheHomeLink indicatorlightwillflash,first
slowly and then rapidly. When the indicator
light begins to flash rapidly, release both
buttons.
Individualbuttonscannotbecleared,howeverto
clear all programming, press and hold the two
outsidebuttonsandreleasewhentheindicator
lightbeginstoflash(approximately20seconds).
PROGRAMMINGTROUBLE
DIAGNOSIS
The HomeLink Universal Transceiver button
has now been reprogrammed. The new device
can be activated by pushing the HomeLink
button that was just programmed. This proce-
dure will not affect any other programmed
If the HomeLink does not quickly learn the
hand-heldtransmitterinformation:
¼
replace the hand-held transmitter batteries
withnewbatteries.
HomeLink
buttons.
IFYOURVEHICLEISSTOLEN
¼
position the hand-held transmitter with its
batteryareafacingawayfromtheHomeLink
surface.
Ifyourvehicleisstolen,youshouldchangethe
codes of any non-rolling code device that has
2-42
Instrumentsandcontrols
| Categories | Nissan Manuals, Nissan Murano Manuals |
|---|---|
| Tags | Nissan Murano 3.5 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)