THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
73
Iftheseatbelthasanautomaticlockingretractor,itwill
have a distinctive label. Pull the belt from the retractor
until there is enough to allow you to pass through the
child restraint and slide the latch plate into the buckle.
Then, pull the belt until it is fully extended from the
retractor.Allowthebelttoreturntotheretractor,pulling
on the excess webbing to tighten the lap portion about
the child restraint. Refer to “Automatic Locking Mode”
earlierinthissection.
to do something more. Disconnect the latch plate from
the buckle, turn the buckle around, and insert the latch
plate into the buckle again. If you still can’t make the
childrestraintsecure,tryadifferentseatingposition.
2
Toattachachildrestrainttetherstrap:
In the rear seat, you may have trouble tightening the
lap/shoulder belt on the child restraint because the
buckleorlatchplateistooclosetothebeltpathopening
on the restraint. Disconnect the latch plate from the
buckleandtwisttheshortbuckle-endbeltseveraltimes
toshortenit.Insertthelatchplateintothebucklewiththe
releasebuttonfacingout.
If the belt still can’t be tightened, or if by pulling and
pushingontherestraintloosensthebelt,youmayneed
TetherStrapMounting(Two-DoorModels)
| Categories | Jeep Manuals, Jeep Wrangler Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)