PEUGEOT TRANSPONDER SYSTEMS
Make – PEUGEOT
Model – 406 (model 2000)
Years – 2000-2004
Immobiliser System: BSI1-2
Software Card: PSA
Diagnostic Equipment: RT3
Diagnostic Lead:
OBD-II+Yellow pod
in
Maximum Keys: 5
JMA Key Blank: NE-51.P2
Code Series: DIRECT
Transp. Type: TP16 ó TP12
Copy Code: NO
OBD II Diagnostic Port
Pin Code Required:
YES, the pin is of 4 characters,
being able to be these letters
and numbers
In PEUGEOT 406 the OBDII socket is located under one
small plastic tape close to the steering wheel.
Technical Information
Before The “Crypto Era” the 406 worked with Transponder Fix code (TP01) and it was possible to clone with
TRS-4000.Later this model can support two different Inmo. Systems (BSI-1 and BSI-2), from 98-00 this model
use the Transponder TP16 and later from 2000 in advance use the TP12.
ATTENTION: the time that is arranged between key and key for the codification is very short (aprox. 3
seconds). Should be quite quick in the keys exchange in the Ignition. When the process of keys codification be
finished, should be expected around 10 minutes before testing the keys.
If for some cause, after keys codification, the keys remote control lost the properties, you must only introduce
into the ignition the Codified key and later put ON the ignition and then push the lock button of the remote,
immediately you will be able to hear the doors activation.
(0 votes, average: 0 out of 5)
Comments are closed.