FORD USA TRANSPONDER SYSTEMS
Make - FORD
Model - MUSTANG
Years - 1999 - 2003
Immobiliser System: HEC
Software Card: Ford USA
Diagnostic Equipment: RT3
Diagnostic Lead: OBD-II
Maximum Keys: 8
JMA Key Blank: FO–15D.P
Code Series: 0001X – 1706X
Transponder Type: TP02
TRS-4000 Copy Code: NO
OBD II Diagnostic Port
Pin Code Required: NO.
The time is the PIN CODE in
FORD cars, you must wait
between 10 to 20 minutes for
connection.
In the FORD MUSTANG USA, the connector is OBD II type and
is found under the steering wheel, Near to the pedals.
Technical Information
The Transponder Immobiliser System requires a ten minute security delay before programming of
additional keys can be performed. The software allows you to add or erase keys up to a maximum of
eight Transponder keys which can be programmed to the immobiliser system. If you chose to erase
keys you must have two newly cut Transponder keys to program into the system before the vehicle
will start. If you have two already programmed keys you do not require Diagnostic equipment to
program additional keys. (Follow the programming instructions provided on the following page.) The
Transponder used on this system is a Texas instrument 4C and you must use the correct Transponder
Key blank for programming. (Please refer to the JMA Transponder Key Blank Guide for correct
Transponder key Blank details.).
(0 votes, average: 0 out of 5)
Comments are closed.