OPEL/VAUXHALL TRANSPONDER SYSTEMS
Make – OPEL-VAUXHALL
Model – VECTRA C
Years - 2002⇒
Immobiliser System: 3 CAN
Software Card: GM
Diagnostic Equipment: RT3
Diagnostic Lead: OBD-II
Maximum Keys: 5
JMA Key Blank: OP-WH.P
Code Series: S/D 1-5200
TransponderType:
Original remote
TRS-4000 Copy Code: NO
Pin Code Required:
YES, 4 Digits which can be
In the OPEL VECTRA C, the connector is OBD II type
found on the
and is found in the central panel, just besides the lighter
OPEL/VAUXHALL car pass
Technical Information
The Transponder used is really one Original Delphi remote, which simulate one Crypto 3º
Generation. The maximum amount of keys you can program to the Immobiliser System is five. The
Software Card allows you to add additional keys, erase keys and program remote handsets. In
addition the Software allows you to read the mechanical key number to cut the key. When you erase
keys you never can codificate again the deleted keys, you need always to codify keys news. The
software provided allows you to add the remote plips function at the same time as you codify the
keys,There is also fault code reading and clear fault codes and live data for more technical
information. The system requires a four digit pin code which can be found on the OPEL/VAUXHALL
car pass supplied with the vehicle from new, if this information is not available you must request this
from the car dealership that will also provide you with the mechanical key number and the radio code
normally there is a charge for this information.
(0 votes, average: 0 out of 5)
Comments are closed.