OPEL/VAUXHALL TRANSPONDER SYSTEMS
Make – OPEL-VAUXHALL
Model - VECTRA
Years – 1997-2002
Immobiliser System: 2
Software Card: GM
Diagnostic Equipment: RT3
Diagnostic Lead: OBD-II
Maximum Keys: 5
JMA Key Blank: OP-WH.P
Code Series: H/Y 1-3000
Transponder Type: TP09
Copy Code: NO
Pin Code Required:
YES, 4 Digits which can be
found on the
In the OPEL VECTRA 97, the connector is OBD II type
and is found under one Plastic tape, beside the Hand Brake
OPEL/VAUXHALL car pass
Technical Information
The Transponder Immobiliser System is known as TIS-1 and TIS-2 and the Transponder used is a
Phillips Crypto Second Generation JMA reference TP15. The maximum amount of keys you can
program to the Immobiliser System is five. The Software Card allows you to add additional keys,
erase keys and program remote handsets. In addition the Software allows you to read the mechanical
key number to cut the key. When you erase keys you will delete all keys from the system and will
program new keys starting from position Transponder Key One. The software provided allows you to
add individual keys, Read keys, Erase keys and program remote plips,There is also fault code reading
and clear fault codes and live data for more technical information. The system requires a four digit
pin code which can be found on the OPEL/VAUXHALL car pass supplied with the vehicle from new,
if this information is not available you must request this from the car dealership that will also provide
you with the mechanical key number and the radio code normally there is a charge for this
information.
(0 votes, average: 0 out of 5)
Comments are closed.