ROVER TRANSPONDER SYSTEMS
Make -ROVER
Model - MGF
Years - 1998 ⇒
Immobiliser System:
Software Card: ROVER
Diagnostic Equipment: RT3
Diagnostic Lead:
OBD-II+GREEN POD
Maximum Keys: 4 Plips
JMA Key Blank: (No transponder)
OBD II Diagnostic Port
Code Series:
Transpond. Type: Orig. Plips
TRS-4000 Copy Code: NO
Pin Code Required: NO
In the ROVER MGF the connector is OBD II type and is
found in the fuse box.
Technical Information
The immobiliser system is activated by remote key fob which also locks doors and sets alarm system,
The key is a normal Key without transponder inside, the fob deactivates the immobiliser by pressing
the unlock button on the remote and also opens doors and turns the alarm system off. There is also a
special override code which can be used to turn the immobiliser and alarm system off this is known as
the EKA code. The JMA RT3 Diagnostic unit can program up to 4 plip keys and can also read the
EKA code this can be used to mechanically start the vehicle if there is a problem with the remote and
there is a special sequence used to perform this operation follow instructions in your key fob
programming guide plip. When programming plip keys or reading EKA codes always use GREEN
pod with standard OBD-II lead to communicate and program plip keys. Insure battery has good
voltage and plip keys have good batteries before performing diagnostic programming procedure.
(0 votes, average: 0 out of 5)
Comments are closed.