1990 Land Rover Defender 90, 110, 130 Td5, Tdi, V8 Workshop Manual

DEFENDER
ENGINE
. .
Remove the  two  bolts  inside the bracket   into
the front  cover and   remove  the bracket   and
triangle shaped packing    plate.
9.
CYLINDER HEAD
Service  Repair No.
Remove  and  refit
Remove  the bonnet    and  disconnect the
battery.
2.
Drain the coolant.
3.
4.
Remove  the radiator   top hose.
Remove  the exhaust   and  inlet  manifolds,
complete with    turbo  charger  see   operation
30.29.02.
5.
Remove  the heater rail.
Remove  the thermostat t    o waterpump   hose.
Disconnect   the electrical   leads fromthe
thermostat   housing sensors.
Disconnect the harness     from  the alternator.
Remove  the heater h   ose from the cylinder
head.
7.
8.
9.
.
Refitting
10.
Remove the axle   breather pipe    bracket  from
the  rear of  the cylinder    head.
10.
Fit  the bracket   to the cylinder block with    the
four  bolts,  reversing  instructions 7   to  9.
Loosely secure the pump    to   the bracket with
the three   bolts.
11.  Remove the fuel    pipes from the injectors     and
injector pump.
12.   Remove the spill return    pipes  from the
injectors.
12.
Fit  and tension   the drive belt.
13.
Remove the   injectors  and washers   and  place  in
a clean,                 container,   for safe keeping.
CAUTION:-  Do not  apply any  pressure
against the   pump casing  when  tensioning
the  drive belt  since  it  will damage  the
casing,  permanently,  beyond   repair.
14. Remove  the electrical   leads from   the  heater
plugs.
15.  Remove the   heater plugs and store in      a safe
place.
13.
Tighten  the  two clamp bolts  and single pivot
bol.  The belt  is  correctly tensioned when the
belt  can be deflected    by thumb pressure    12
16.  Remove the   hose from the     breather  valve.
17.  Follow the   instructions   in  the  ENGINE
OVERHAUL  section  12.  SEE  INDEX:-
Operations   with  engine   installed  in  vehicle.
14.
Fit  the alternator and    tension  the drive  belt,
see operation    86.10.02.
Fit  the air  cleaner.
I
.
16.  Connect   the  battery,  run the engine at    a fast
idle for  approximately three   to five minutes.
Stop the engine and check     the drive   belt
tensions.
Continued
33
Product Specification
CategoriesLand Rover, Land Rover Defender 110, Land Rover Defender 130, Land Rover Defender 90
Tags
Model Year1990
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 102 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 90, 110, 130 Td5, Tdi, V8
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field