1990 Land Rover Defender 90, 110, 130 Td5, Tdi, V8 Workshop Manual

DEFENDER
STEERING
POWER STEERING   PUMP
Service  Repair No.  57.20.14
Remove  and  refit
Refitting
,
7.  Fit  the adjustment plate     to  the pump aligning
the marks  made w  hen dismantling   and secure
with  the four bolts.
8.
Fit  the drive  pulley  and retain   with  the four
1.
Working  from  beneath  the vehicle,   release the
drive  belt  tension  by slackening  the  two
adjustment clamp    bolts  and  the single  pivot
bolt  and remove the belt.
screw.
9.   Fit  the pump and adjustment plate       to the
engine bracket   and  loosely secure with     the
pivot  bolt  and  two adjustment clamp    bolts.
10.
Fit  the drive  belt  and  lever t he pump away
from  the engine t  o tension    the  belt  and
tighten  the  two clamp bolts    and single pivot
bolt.  The belt  is correctly tensioned when,      at
the mid-point   of  its run  it can   be deflected    by
thumb  pressure
CAUTION: Do  not  apply  any pressure
against  the  pump'casing   when  tensioning
the  drive  belt since   it will  damage   the
casing  permanently,   beyond   repair.
11.
Connect the fluid    hose and secure with      the
clip.
Fit  the banjo   bolt  ensuring that   a special   steel
washer  is fitted  each side  of the   banjo.
Top up  the fluid   reservoir with   the correct
make  and  grade  of fluid, see   section  09.
Run the engine and     turn  the steering from    lock
to lock.   Re-check  the  fluid  level and  the drive
belt  tension.  Also examine   for fluid  leaks.
1
13.
Disconnect from   the pump,   the supply   hose
from  the fluid  reservoir and drain   into  a
suitable container.
Remove the   banjo  union  bolt  from the rear  of
the pump and    allow fluid to drain into a
container.
Remove the three    bolts  slackened  in
and  remove  the pump complete
with  adjustment plate   and pulley.
Remove the   four  bolts  to release  the drive
pulley  from  the pump hub.
14.
3.
4.
5.
1.
Pulley
Adjustment  plate
Pump
6.
7.
8.
9.
Banjo
bolt
instruction
3.
4.
5.
inlet  hose
'0'
rings
10.    Union  nut
6
.  Since the adjustment     plate  can be fitted   in
more than   one position    on the pump,   mark
the relationship   of  the pump   to the plate
before removing    the four attachment    bolts.
M
95
Product Specification
CategoriesLand Rover, Land Rover Defender 110, Land Rover Defender 130, Land Rover Defender 90
Tags
Model Year1990
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 102 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 90, 110, 130 Td5, Tdi, V8
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field