DEFENDER
ENGINE
OVERHAUL AND FITTING OIL FILTER ADAPTOR
Oil temperature thermostat
Oil filter
6. Smear the filter sealing ring with oil and screw
the filter clockwise until the seal touches the
machined face, then tighten the filter a further
half turn only. Do not over tighten. see
Remove the two bolts and carefully withdraw
the thermostat extension housing complete
with, the ’0’ring
Maintenance operations, section 10.
and spring
Clean the adaptor housing
(6) with
lint-free cloth.
Fitting vacuum pump
inspect all the parts and renew as necessary.
7. Using a new gasket fit the vacuum pump so
that the brake
connection is towards the
3.
Fit the spring, washer and thermostat with the
pin uppermost.
front of the engine, ensuring that the cross-pin
in the skew gear locates in the pump drive
shaft then secure with three screws tightened
to the correct torque.
4.
Fit the extension housing using a new ’0’ring.
Ensure that the pin protruding from the
thermostat locates in the hole in the extension
housing and secure with the two bolts and
washers.
\
5.
Using a new joint washer fit the oil filter
adapto. Ensure that the retaining bolts pass
through the two small holes in the joint
washer. Tighten the two retaining bolts evenly
to the correct torque.
Fitting front and rear side covers and fuel lift
8.
Check that the front side cover baffle plate is
secure and fit the cover using a new gasket
securing with only four of the six fixing bolts at
this stage, leaving out the two which secure
the injection pump support bracket as
illustrated.
66
Categories | Land Rover, Land Rover Defender 110, Land Rover Defender 130, Land Rover Defender 90 |
---|---|
Tags | Land Rover |
Model Year | 1990 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Defender 90, 110, 130 Td5, Tdi, V8 |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)