DEFENDER
ENGINE
Fitting rear cover
3. Also fit a new joint washer t o the coolant
aperture and to the tapped hole for the jockey
pulley clamp bolt.
4. Fit the front cover locating it over the single
stud and secure with the three retaining bolts
tightening evenly to the correct torque. The
correct bolt length for each hole is given in
the following chart.
9.
Fit the rear cover also using a new gasket and
secure with six bolts tightened to the correct
torque.
Fitting fuel lift pump
10.
Check that the lift pump is serviceable and refit
using a new gasket, ensuring that the pump
actuating lever locates correctly onto the
camshaft .
,
FRONT COVER TIMING BELT AND GEARS
Front cover seals
1.
Clean the front cover and remove t he
crankshaft and camshaft oil seals taking care
not t o damage the seal housing. Examine the
cover for damage, cracks and distortion. Check
the mating face of the cylinder block and the
cover plate f or burrs.
5. Lubricate a new crankshaft oil seal. With the lip
side leading, drive-in the seal, squarely, using
special service tool
6.
Similarly, lubricate and drive-in a new camshaft
oil seal, lip side leading, using special service
tool
Clean the front face of the cylinder block and
use a little grease t o hold in position a new
washer.
67
Categories | Land Rover, Land Rover Defender 110, Land Rover Defender 130, Land Rover Defender 90 |
---|---|
Tags | Land Rover |
Model Year | 1990 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Defender 90, 110, 130 Td5, Tdi, V8 |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)