1990 Land Rover Defender 90, 110, 130 Td5, Tdi, V8 Workshop Manual

DEFENDER
ENGINE
Fitting rear main  oil seal  to  flywheel   housing
1.  Make sure the seal    housing  is  clean  and  dry
and free from   burrs.  Do  not  touch  the seal   lip
and  ensure that the outside     diameter  is   clean
and dry.
The oil  seal is manufactured   from  P.T.F.E.  and  is
supplied with  a former t  o maintain  the correct s   hape
which must not   be removed    until  the seal  is to be
fitted.
2.   Using special seal
1 and with
the lip  side leading   drive-in the seal   as far  as
the tool   allows.  If  the tool   is not available  fit
the seal t  o the bottom   of  the housing    to
ensure squareness.
18G
Fitting flywheel   housing
3.
Clean  the rear  face of  the cylinder block   and
flywheel  housing,  then apply a   bead  of  Hylosil
1
02 sealant t  o the dimensions    and
configuration,   illustrated.
The  illustration  has  been  produced full  size so  that  a
template   may be made t  o facilitate the application
.
of  the sealant. The   bead  should  be
diameter
and  must  extend around   the periphery    of the
bearing  cap  so that  the joint  between   cap and   block
is sealed.
60
Product Specification
CategoriesLand Rover, Land Rover Defender 110, Land Rover Defender 130, Land Rover Defender 90
Tags
Model Year1990
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 102 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 90, 110, 130 Td5, Tdi, V8
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field