Convenient features of your vehicle
To adjust the Zone setting:
If you need to recalibrate the com- Integrated HomeLink® Wireless
Number based upon your current 1. Press and hold the
more than 6 seconds. When the System can replace up to three hand-
compass memory is cleared a "C" held radio-frequency (RF) transmit-
button for The HomeLink ® Wireless Control
location on the Zone Map.
Press and hold the
more than 3 but less than 6 sec-
will appear in the display.
ters with a single built-in device. This
innovative feature will learn the radio
frequency codes of most current
transmitters to operate devices such
as gate operators, garage door open-
ers, entry door locks, security sys-
tems, even home lighting. Both stan-
dard and rolling code-equipped trans-
mitters can be programmed by fol-
lowing the outlined procedures.
onds, the current Zone Number 2. Drive the vehicle in 2 complete cir-
will appear on the display.
Pressing and holding the
cles at less than 5 mph (8 km/h).
again will cause the numbers to
increment (Note: they will repeat
14, 15, 1, 2, …). Releasing
the button when the desired Zone
Number appears on the display
will set the new Zone.
Additional HomeLink ® information
can be found at: www.homelink.com
or by calling 1-800-355-3515.
Retain the original transmitter of the
RF device you are programming for
Within about 5 seconds the com-
pass will start displaying a com-
pass heading again.
There are some conditions that can
cause changes to the vehicle mag-
nets, such as installing a ski rack or
a CB antenna. Body repair work on
the vehicle can also cause changes
to the vehicle’s magnetic field. In
these situations, the compass will
need to be re-calibrated to quickly
correct these changes.
use in other vehicles as well as for
future HomeLink® programming. It is
also suggested that upon the sale of
HomeLink® buttons be erased for
|Categories||Hyundai Manuals, Hyundai Sonata Manuals|
|Document Type||Owners Manual|
|Product Brand||Hyundai, Sonata|
|Document File Type|
(0 votes, average: 0 out of 5)