4.
Firmly press, hold for 5 seconds and
release the programmed
HomeLink® button up to two sepa-
rate times to activate the door. If the
door does not activate, press and
hold the just-trained HomeLink® but-
ton and observe the indicator light.
Flashing
i Information
Some devices may require you to
replace this Programming step 3 with
procedures noted in the "Gate
Operator/Canadian Programming"
chapter. If the HomeLink® indicator
light does not change to a rapidly
blinking light after performing these
3
•
If the indicator light stays on con-
stantly, programming is complete
steps,
contact
HomeLink ®
at
and your device should activate
when the HomeLink® button is
pressed and released.
www.homelink.com.
ODH044414N
2.
3.
Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
away from the HomeLink® button
you wish to program while keeping
the indicator light in view.
Simultaneously press and hold
both the HomeLink® and hand-
• If the indicator light blinks rapidly
for 2 seconds and then turns to a
constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
held transmitter buttons until the
HomeLink® indicator light changes
5. At the garage door opener receiv-
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
from a slow to a rapid blinking
light. Now you may release both
the HomeLink ® and hand-held
transmitter buttons.
3-25
| Categories | Hyundai Manuals, Hyundai Sonata Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Sonata |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)