UNDERSTANDINGTHEFEATURESOFYOURVEHICLE
119
ParkingLights,InstrumentPanelLights,and
Headlights
Turn the end cap of the multi-function control lever to the
first detent for parking lights and instru ment panel
lights. Turn to the second detent for head light operation.
PassingLight
You can signal another vehicle with you r head lights by
lightly pulling the multi-function control lever tow ard
the steering wheel. This will cause the head lights to turn
on at high beam and rem ain on until the lever is released .
The “High Beam Ind icator Light” will illuminate when
the high beam s are on.
3
To change the brightness of the instru ment panel lights,
rotate the center portion of the multi-function control
lever up or down.
TurnSignals
Move the multi-function control lever up or down and
the arrow s on each side of the instru ment cluster flash to
show prop er operation of the front and rear turn signal
lights. You can signal a lane change by moving the lever
partially up or down withou t moving beyond the detent.
HighBeam/LowBeamSelectSwitch
Pull the multi-function control lever tow ard s you to
switch the head lights to HIGH beam . Pull the multi-
function control lever a second time to switch the head -
lights to LOW beam . The “High Beam Ind icator Light”
will illuminate when the high beam s are on.
If either light flashes at a very fast rate, check for a
defective outsid e light bulb. If an ind icator fails to light
when the lever is moved , it would suggest that the fuse
or ind icator is defective.
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2005 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)