12
ENGINE
Refit
16.
17.
Clean sealant from threads of cover bolts.
Clean old sealant from front cover and block joint
face.
CAUTION: Use a plastic scraper.
18.
Apply Hylosil jointing compound to gasket
position on cover and block.
19.
20.
21.
Fit new gasket to block face.
Ensure oil seal register in cover is clean.
Lubricate outer face of NEW oil seal.
9.
Disconnect multiplug from camshaft sensor.
See FUEL SYSTEM SFI, Repair, Camshaft
Position Sensor (CMP Sensor)
10.
Remove 9 bolts securing front cover.
22.
23.
Using LRT-12-089, fit seal to cover.
Lubricate oil pump drive gear and position in
pump with groove away from engine.
11.
12.
Remove 2 bolts securing sump to front cover.
Loosen 4 bolts securing sump adjacent to front
cover (2 each side).
13.
14.
15.
Release front cover assembly.
Remove oil seal.
Remove and discard gasket.
24.
Locate alignment tool LRT-12-090 on front cover
and oil pump drive gear.
25.
26.
Position front cover over crankshaft.
Press and rotate tool to engage drive gear until
drive gear keyway aligns with Woodruff key.
Fit cover to cylinder block.
27.
8
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)