1998 Land Rover Workshop Manual

57
STEERING
POWER STEERING SYSTEM - TEST
Procedure
NOTE: If steering lacks power assistance.
Check pressure of hydraulic pump before
fitting new components. Use fault
1.  A hydraulic pressure gauge and test adaptor is
used to test power steering system. This gauge
is able to measure 140 kgf/cm
power steering system pressure is 77 kgf/cm
Some fault conditions of hydraulic pump may
obtain pressures up to 105 kgf/cm . Pressure on
2
. The maximum
diagnosis chart to assist in tracing faults.
2
.
2.
2
gauge is same pressure being exerted upon
steering wheel. When testing, turn steering
wheel gradually while reading pressure gauge.
Check and maintain maximum fluid level of
reservoir.
Examine power steering units and connections
for leaks. All leaks must be rectified before
attempting to test the system.
3.
4.
5.
6.
Check steering pump drive belt tension. See
ENGINE, Repair,  Drive Belt
Assemble test equipment and fit to vehicle, as
shown in RR3959M.
7.
8.
Open tap of adaptor.
Bleed system, take care not to overload
pressure gauge.
9.
With system in good condition, pressures should
be:
(A)
(B)
Steering wheel held on full lock and engine
running at 1,000 rev/min, 70 to 77 kgf/cm
Steering wheel held on full lock and engine
idling, 28 kgf/cm
2
.
2
.
Checks should be carried out on both full lock
positions.
CAUTION: Do not maintain this pressure
for more than 30 seconds in any one
minute to avoid overheating fluid and
possibly damaging seals.
10.
Release steering wheel and with engine idling.
Pressure should read below 7 kgf/cm
A.
B.
C.
D.
E.
F.
G.
H.
Steering box.
Steering pump.
2
.
11.
12.
If pressures differ to those given a fault exists.
To determine if fault is steering box or pump.
Close adaptor tap for a maximum five seconds.
If gauge does not register specified pressure,
pump is faulty.
Fit a new pump, bleed system and repeat test. If
low pressure or a substantial imbalance exists,
fault is in steering box valve and worm
assembly.
Existing hose, steering box to pump.
Hose LRT-57-030.
Test adaptor LRT-57-001.
Pressure gauge LRT-57-005.
Thread adaptor LRT-57-004.
Thread adaptor LRT-57-022.
13.
14.
2
FAULT DIAGNOSIS
Product Specification
CategoriesRange Rover
Tags
Model Year1998
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 873 pages
Document TypeWorkshop Manual
LanguageEnglish
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field