86
ELECTRICAL
DIGITAL DIESEL SHUT-OFF VALVE (DDS) - 97 MY
Service repair no - 86.77.00
Remove
ANTENNA AMPLIFIER - 97 MY
Service repair no - 86.50.29
Remove
1.
2.
Remove fuel injection pump. See FUEL
SYSTEM, Repair, fuel injection pump and
timing
Drill into 2 break-off screws to a depth of
approximately 5 mm using a 3.2 mm drill.
1. Remove RH alpine light trim casing. See
CHASSIS AND BODY, Repair, alpine light
trim casing
CAUTION: Use a drill bushing to guide the
drill during the above.
3.
Using an ’Easy-out’ remove 2 valve retaining
screws and discard.
4.
5.
Release DDS valve from fuel shut-off solenoid.
Remove protective cap from fuel shut-off
solenoid electrical connection.
6.
Remove fuel shut-off solenoid terminal nut and
remove DDS valve.
Refit
7.
2.
3.
Release amplifier to sixth light connector and
seal finisher.
Remove screw securing amplifier to body and
release from location.
Disconnect co-axial cable from amplifier.
Disconnect Lucar from amplifier.
Remove amplifier.
Position DDS terminal lead to fuel shut-off
solenoid and secure with nut tightened to 2 Nm .
Position DDS valve to fuel shut-off solenoid .
Position clamping plate to DDS valve and tighten
shear bolts simultaneously until heads shear.
Fit fuel injection pump. See FUEL SYSTEM,
Repair, fuel injection pump and timing; Refit
8.
9.
4.
5.
6.
10.
Refit
7.
Fit amplifier, connect co-axial cable and Lucar to
amplifier.
8.
Position amplifier to location and secure with
screw.
9.
Secure amplifier lead through seal finisher and
connect to sixth light.
10.
Fit RH alpine light trim casing. See CHASSIS
AND BODY, Repair, alpine light trim casing;
Refit
50
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)