Tdi
VISCOUS COUPLING, FAN BLADES, PULLEY AND
FAN COWL
THERMOSTAT
Service repair no - 26.45.01
Remove
Service repair no - 26.25.03/05
Viscous coupling
Fan blades
Fan cowl
- Remove 1 to 3
- Remove 1 to 4
- Remove 1 to 3
- Remove 1 to 6
1. Partially drain cooling system, until coolant level
is below thermostat housing.
2. Disconnect hose from thermostat housing.
Fan pulley
3.
Disconnect electrical connections to water
temperature switch.
Remove
WARNING: Disconnect battery negative
terminal to prevent engine being started
before removing or adjusting drive belt.
1.
Slacken nut securing viscous coupling/fan blade
assembly to pulley.
NOTE: Nut securing viscous unit to pulley
has a left hand thread. Release by turning
clockwise when viewed from front of
viscous unit.
2.
3.
Drop viscous unit and fan assembly into bottom
of cowling
Remove two fixings clips from top of cowling and
lift cowling complete with viscous unit and fan
out of lower mountings.
4.
5.
6.
Remove fan blades from viscous coupling if
necessary.
Remove serpentine drive belt and, if fitted, air
conditioning compressor belt.
Remove pulley fixings, remove pulley.
4.
Remove outlet elbow.
NOTE: The serpentine belt is removed by
using a hexagonal socket and tommy bar
on the auto-tensioning pulley nut. Whilst
5. Withdraw thermostat.
Test
tensioning the device the belt can be removed.
6.
Note rating of thermostat is 88°C. Place
thermostat in a container half full of water. Heat
water, observe temperature at which thermostat
begins to open. Thermostat is satisfactory if its
open between 85°C and 89°C.
7.
Reverse removal procedure. Ensure fan blades
are fitted correctly. Fan is marked ’front’ and
should be fitted with word ’front’ closest to
radiator. Tighten to 30 Nm.
8.
Refit drive belt. See ENGINE, Repair, Drive
Belt
Refit
7.
Insert thermostat with jiggle pin/vent hole upper
most (12 o’clock position) .
8.
Fit the outlet elbow and new joint washer.
Tighten to 28 Nm.
9.
10.
Reverse removal procedure. 1 to 3.
Check for coolant leaks around all connections
and joint faces.
REPAIR
1
Product Specification
Categories | Range Rover |
---|---|
Tags | Land Rover |
Model Year | 1998 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |