V8i
THERMOSTAT
Refit
Service repair no - 26.45.01
Remove
7. Insert thermostat with jiggle pin/vent hole
uppermost (12 o’clock position).
8. Fit the outlet elbow and new joint washer.
Tighten to 28 Nm.
1.
Partially drain cooling system, until coolant level
is below thermostat housing.
Disconnect hose from thermostat housing.
Disconnect electrical connections to water
temperature switch.
9. Reverse removal procedure. 1 to 3.
10. Check for coolant leaks around all connections
and joint faces.
2.
3.
4.
5.
Remove outlet elbow.
Withdraw thermostat.
Test
6.
Note rating of thermostat is 88°C. Place
thermostat in a container half full of water. Heat
water, observe temperature at which thermostat
opens. Thermostat is satisfactory if it opens
between 85°C and 89°C.
REPAIR
3
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)