ELECTRICAL
EXTERIOR DRIVING MIRRORS
Service repair no - 76.11.10
Replacing the mirror glass
Complete assembly
Service repair no - 76.11.10
Remove
1.
2.
Press the outer end of the glass inwards to its
full extent.
Insert the fingers under the inner end of the
glass and pull outwards until the glass is
released from its two retaining clips.
1. Disconnect battery negative lead.
2.
Carefully prise off interior finisher to reveal
retaining plate and securing screws.
Disconnect electrical plug.
Supporting the mirror assembly remove three
securing screws and retaining plate.
Detach mirror assembly from outer door frame.
3.
4.
5.
Refit
6.
3.
4.
5.
Disconnect the two demister leads attached to
the back of the glass unit.
Reverse removal procedure.
To replace the glass, locate the inner end of the
glass in the retaining clip of the housing first.
Carefully press the outer end of the glass
inwards until it securely locates in the front
retaining clip.
NOTE: To prevent damage to the electrical
lead ensure that it is not pushed down
inside the door casing.
6.
Reset the fine adjustment as required.
REPAIR
13
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)