19
FUEL SYSTEM
RAM HOUSING
INTAKE MANIFOLD
Service repair no - 30.15.08
Remove
Service repair no - 19.70.04
Remove
1.
2.
Disconnect battery negative lead.
Remove plenum chamber. See Plenum
Chamber
Release hoses from ram housing.
Remove six through bolts (with plain washers)
securing ram housing to intake manifold.
1. Depressurise fuel system. See Depressurising
Fuel System
2. Disconnect battery negative lead.
3. Drain cooling system. See COOLING SYSTEM,
Repair, Radiator
3.
4.
4. Remove plenum chamber. See Plenum
chamber
5.
Remove ram housing. See Ram Housing
CAUTION: Place a protective cover over
intake manifold openings to prevent the
ingress of dirt.
6.
7.
Disconnect the fuel temperature sensor and
injector multiplugs.
Remove fuel pressure regulator. See Fuel
Pressure Regulator
5.
6.
Remove ram housing from intake manifold.
Place a protective cover over inlet bores to
prevent ingress of dirt.
Refit
7.
8.
9.
Clean all mating faces.
8.
9.
Disconnect multiplug from coolant temperature
sensor.
Disconnect instrument pack temperature
thermistor.
Apply ’Hylomar’ sealant to intake manifold face.
Fit ram housing. Tighten bolts, working from two
centre bolts, diagonally towards outer four bolts.
Tighten to 26 Nm.
10.
10.
Disconnect coolant sensor multiplug.
14
REPAIR
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)