SUPPLEMENTARY RESTRAINT SYSTEM
STEERING WHEEL
Service repair no - 57.60.01
Remove
1.
2.
Remove driver’s airbag module. See driver’s
airbag module.
Position steering wheel so the road wheels are
in the straight ahead position.
8.
9.
Disconnect harness connector from airbag
module.
Remove airbag module.
CAUTION: Store the airbag module in
accordance with the storage procedures
outlined in Description and Operation.
NOTE: If airbag module is to be replaced
the serial numbers must be recorded in
the vehicle service record.
3. Disconnect cruise control switch connector
(where fitted) from rotary coupler harness.
4. Release harnesses from clip on steering wheel.
Refit
5.
Remove steering wheel nut.
10.
11.
Reverse removal procedure.
6. Release steering wheel from column.
7. Feed harnesses through hole in steering wheel.
8. Remove steering wheel.
Connect harness connector to airbag module
with harness downwards (as shown at 8).
Position airbag module on steering wheel and
engage retained screws. Use special socket to
tighten screws to 8Nm (6 lbf ft).
12.
CAUTION: Prevent rotation of rotary
coupler once steering wheel is removed.
Secure in position with adhesive tape.
CAUTION: Take care not to cross thread
screws.
13.
Check Supplementary Restraint System using
Testbook .
REPAIR
3
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)