Tdi
Method 2.
FLYWHEEL HOUSING
Thread the bore of the existing bush and using a
suitable bolt extract the bush. Thoroughly clean bush
location ensuring all swarf is removed.
Service repair no - 12.53.01
Remove
Fitting
1.
Disconnect battery negative lead.
6.
Fit new bush using a suitable shouldered drift,
inserting bush flush with end of crankshaft.
Refit flywheel. See Flywheel
Refit clutch. See CLUTCH, Repair, Clutch
Assembly
Refit gearbox. See MANUAL GEARBOX,
Repair, R380 Manual Gearbox
Reconnect battery negative lead.
2. Remove gearbox. See MANUAL GEARBOX,
Repair, R380 Manual Gearbox
3. Remove clutch. See CLUTCH, Repair, Clutch
Assembly
4. Remove flywheel. See Flywheel
5. Remove starter motor.
6. Remove two bolts from top of flywheel housing.
7. Remove four bolts from bottom of flywheel
housing.
7.
8.
9.
10.
8.
Remove six inner bolts and lift off flywheel
housing.
Refit
9.
Clean rear face of housing and mating face on
block, ensuring all old sealant is removed.
REPAIR
17
| Categories | Range Rover |
|---|---|
| Tags | Land Rover |
| Model Year | 1998 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)